My AccountLogin +


PD Detector

The AIAcompact is a portable unit for in-service acoustic and electric (UHF) partialdischarge measurements on gas-insulated switchgear (GIS), transformers, and cable accessories.


AIAcompact's PC Software

Offering easy-to-use acoustic partial discharge analysis of gas-insulated switchgear (GIS) and other high voltage equipment plus the optional analysis on embedded or external UHF sensors makes the AIAcompact the ideal solution for convenient in-service substation condition assessment.


It is fitted with a battery pack for independent operation up to three hours. The instrument adapts to a variety of piezo-electric acoustic sensors and is supplied with a versatile sensor fixture. Additionally, the AIAcompact allows partial discharge measurements on external UHF sensors.

Acoustic partial discharge measurements can be easily applied on gas-insulated switchgear and other high voltage equipment without the need of interrupting the operation. Such online measurements help to identify internal imperfections of the insulation system, which may lead to breakdown and system failure in the future.

Acoustic partial discharge measurements rely on the close acoustic contact of the area producing the discharge to the point of access, where the sensor is placed. Most of the partial discharge activity in GIS offer such a good contact and, hence, can be detected at a good sensitivity. Therefore, discharges from sharp points or cones as well as discharge activity from delaminations can be identified at a sensitivity that is mostly comparable to the conventional electrical detection according to the IEC 60270. For some defect types, such as the so-called hopping or bouncing particles, the acoustic detection is by far superior to the electrical detection.

Based on the proven hardware core of the ICMcompact, the AIAcompact offers automatic detection of the sensor or preamplifier used. Normally, the instrument is operated with acoustic sensors with remote supplied embedded preamplifiers directly connected to the signal input. Alternatively, the RPA1F can be inserted close to the sensor to boost the signal, in case longer signal cables are used or in case of low-level measurements.

UHF measurements on embedded or external sensors are possible with the use of the FCU2, a logarithmic frequency converter, which covers 100 MHz to 1800 MHz. As with the preamplifiers, the AIAcompact automatically detects the FCU2 and changes into the logarithmic display for the UHF detection. To protect the instrument's hardware it is advisable to connect an input protection unit like IPU2B to the sensor's output.

For PD measurements in environments with high frequency disturbance the AIAcompact offers an efficient software controlled noise reduction.

Display Modes

The instrument offers three display modes, which are selected using dedicated control buttons: SCOPE, METER, and TIME.


In SCOPE mode, the AIAcompact shows the phase-resolved partial discharge signal or pattern. Here, the 'Freeze' function allows keeping such a captured pattern for further evaluation or for taking screenshots.


The METER mode offers four bar graph displays showing derived quantities of the captured activity. The graphs display the RMS and the peak PD level, as well as their 50 Hz (60 Hz) and 100 Hz (120 Hz) content. The instrument automatically synchronizes to the line frequency.


Within the TIME mode, the AIAcompact displays five or ten AC cycles triggered by a partial discharge event. Thus, this display shows the pattern of consecutive partial discharge events and, hence, offers a clear identification of bouncing particles and the severity of their activity.