Testes de oficina (QA e P&D)

Power Diagnostix offers easy to use instruments for the daily acceptance tests and quality control on cables according to the IEC 60270 or other relevant testing standards.

Testes de descarga particular em cabos de energia em uma fábrica

All cables produced in a cable factory need to be tested according to the relevant quality assurance standards. During the high voltage tests a simultaneous PD measurement is recommended and applicable. Depending on the highest voltage levels under test a suitable coupling capacitor can be used to pick up the PD signal from the cable termination.

Dissociação de descarga parcial em uma terminação de cabo

The following table shows an overview of applicable standards for cables and accessories tested after production.

[Translate to Portuguese:] IEEE table of relevant testing standards

Pacotes típicos

Standard PD test system:

1 x ICMcompact (opt. MUX4, gating)
1 x ICMcompact software
1 x Preamplifier RPA1
1 x Coupling capacitor like CC50B/V, CC100B/V, CC200B/V, for instance
1 x Impulse calibrator CAL1A
1 x Set of cables
1 x Software for remote control, recording, and reporting

Banco de teste de descarga parcial

Extended automated HV test system:

HVcontrol with STEP option
HVpilot software
PD test equipment as listed above

Descarga parcial como exibição de osciloscópio

HVcontrol